Mix Bed Unit

Mix Bed Unit, Mixed Bed Manufacturer, Mixed-Bed Demineralizer

Water and Process Solutions / Mix Bed Unit:

Raindrops Water Technologies can design and make mixed bed polishing units to suit all of customer’s need. Cation and Anion resins are combined in a MSRL of FRP vessel to produce ultra pure water.

Usually a mixed bed unit contains strong acid Cation (SAC) resin and strong base Anion (SBA) resins combined to a ratio of approximately 40% Cation resin to 60% Anion resin. (All resin volumes are dependent upon the feed water analysis and the required quantity of treated water). Mixed bed polishers are typically installed when a water quality of less than 1 micro ohm conductivity is required. Normally mixed bed polishers are installed after a standard Reverse Osmosis or De mineraliser (DM Plant), to produce ultra high quality water.

The Cation resins in mixed bed units are of a higher specific gravity and settle at the bottom of the vessel at the same time the Anion resin will automatically float to the top.

Please note: The Cation resin must be a strong acid Cation type (SAC) and the Anion resin must be a strong base Anion resin (SBA)

After a service cycle, each resin is regenerated as below:

- (SAC) : Strong Acid Cation resin is washed with approx. 30% hydrochloric acid.
- (SBA) : Strong Base Anion is washed with approx. 26% caustic.

Please note: The above regenerate strengths refer to the values before being diluted by the mixed bed unit educator systems. Please contact Raindrops Water Technologies for further details.

Copyright © 2013 3gaqua.in All Rights Reserved 3G Aqua Chemicals Pvt Ltd. Designed by: Pixmiracle Multimedia